How to remove the doors from a new Jeep Wrangler

How to remove the doors from a new Jeep Wrangler

3 minutes, 14 seconds Read





For those with experience with previous model year Wranglers, removing the doors wasn’t much of a challenge, provided you keep the included tool kit safe. Previously, the doors were attached to the Wrangler using Torx bolts, which had to be loosened and removed. However, Jeep has updated the Wrangler’s doors with a new design, which should make the door removal process even easier.

Instead of loosening the fasteners bolted into the body, the latest Wranglers feature a vertical quick-release pin (called a check-arm pin), which pulls the door out and unlocks it. While there are still some necessary steps carried over from pre-2026 models, such as disconnecting the wiring, the new system should save Wrangler owners a lot of time. However, before you do this, be aware of every condition that allows you to drive your Jeep without doors, and don’t forget about side mirrors. So, what are the steps for removing the doors from the Wrangler with the new design?

Removing the doors from the latest Jeep Wrangler

The first step of the process is to put down your windows before removing your doors so that they are secured in the door. Next you’ll want to locate the wiring (if your Jeep has power windows and door locks). On most Wranglers, the wiring harness on the front doors is covered with nylon that runs from the door to the body of the Jeep. The rear doors may differ slightly. Now you need to loosen the nylon strap. You should see a small hook where the nylon strap is looped around. Simply slide that loop up and remove the nylon connection to the vehicle body. If you’re having trouble, try creating some slack by opening the door only partially, rather than all the way.

The wiring harness cover is located behind an inner cover next to the door hinges of the front doors. Carefully remove the cover and then loosen the harness. For front doors, there are two mechanisms that keep the wires connected: a red clip and a white plastic piece that locks them in place. Slide the red clip up first, then rotate the white portion by pressing the lowest point up so it can swing up and disconnect the wires. Finally, locate the pin on the hinge mechanism and pull it up, allowing it to slide out of the hinge. Once both pins are removed, simply lift the door and it should release from the Wrangler. Jeep indicates that this part requires a second person, and given the weight of the doors, that’s probably not a bad idea.

Advantages and disadvantages of working doorless

The most common place to see Wranglers without doors is in off-road scenarios. It’s not necessary to go doorless to have a good time in the backcountry, but some favorite off-road experiences often include many doorless Jeep activities. And that’s only natural, as the doorless Jeep experience has some inherent advantages. On low-speed technical trails, without doors, you can lean out and get a better vantage point on terrain obstacles near the tires. Additionally, the doors themselves add noticeable weight to the Jeep, which once removed allows the Wrangler to shed many pounds, potentially improving performance.

One big caveat: If you decide to go without doors, you’ll need a secure place for door storage. You don’t want your doors to fall over and hit the floor, breaking the glass. For example, you can use moving boxes to create space for the doors so that any scratches are minimized when you lay them flat. Alternatively, there are also ways to hang them along the wall of your garage, using special hooks made specifically for this purpose. You can find options around $30 at some online retailers. Jeep and some online retailers also make and sell door-specific storage bags or storage racks, but they are a little more expensive.



#remove #doors #Jeep #Wrangler

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *