Would you like to know how to adjust a Cobra King TEC Mini Driver to change loft and lie angles? We have a complete guide to the FutureFit33 hostel.
The Cobra King TEC Mini Driver is fully adjustable with a Hosel and gives you the ability to adjust the loft to increase or decrease your launch angle thanks to the FutureFit33 Hosel with up to 33 different loft and lie settings.
The amount of golf driver adjustment What you can do varies per brand, but the step-by-step plan below shows you how the Cobra King TEC Mini Driver can be adjusted.
Cobra King TEC Mini Driver Lofts
The Mini Driver comes standard with a loft of 13.5 degrees, which is adjustable by four degrees (2 up and 2 down). The Hosel also allows for a flatter lying position of 2 degrees.
Cobra King TEC Mini Driver Specifications
Attic: 13.5 degrees
Standard length: 43.75 inches
Standard lie: Standard position of 58.5 degrees
Adjustability: 11.5-15.5 degrees loft and 56.5-60.5 degrees lie
Adjusting the loft angle of a Cobra King TEC Mini Driver
There are a few simple steps you can take to adjust the loft angle of your driver. All you need is an adjustment tool or a wrench to get started.
This is how you can adjust a Cobra King TEC Mini Driver:
1. Locate the screw on the sole of your Mini Driver that secures the drive head to the axle.
2. Using the wrench, loosen the screw by turning counterclockwise.
3. Once the screw is fully loosened, you can rotate the adjustable hose to a lower cage or a higher cage depending on your preference. You will notice the loft figure you had the driver set to and you can rotate the shaft to up to 33 other options.
The available options of the FutureFit33 hostel adjustment are:
Examples:
- Fight a slice: use upright reclining settings or closed facial angles (e.g. B1, C1 or C8) to promote a draw
- Fixing a hook: Use flatter lie settings or open face angles (e.g. A8, A7 or B6) to promote a fade
- Maximize distance / high launch: increase loft (go up on the map, e.g. F4 or G3)
- Windage/Low Launch Control: Use lower loft settings such as G3, G4, or F3
4. Once you have rotated the hosel to the desired loft and lie setting, slide the shaft back into your club head. Your new loft will be displayed through the window on most drivers.
5. Replace the screw and tighten it clockwise with the wrench. When it is completely tight, you will hear a crank that sounds like the driver is creaking. At this point the screw is tightened as much as necessary.
Each time you want to adjust the coop or mooring, repeat this process.
#Customize #Cobra #King #TEC #Mini #Driver #Customization #Guide