How to Adjust a Callaway Quantum Driver (Customization Guide)

Want to know how to adjust a Callaway Quantum driver to change loft and lie angles? We have a complete guide and adjustment table.

The Callaway Quantum Driver Series is the brand’s 2026 model and is fully adjustable with a Hosel that gives you the ability to adjust the loft to increase or decrease your launch angle.

The amount of golf driver adjustment What you can do varies per brand, but the step-by-step plan below shows you how the Callaway Quantum drivers can be adjusted.

Callaway Quantum Drivers Lofts

The Triple Diamond and Triple Diamond Max are available in 8 degrees, 9 degrees and 10.5 degrees.

The Max D is available in 9 degrees, 10.5 degrees and 12 degrees.

The TD-TD model is sold in 9 degrees and 10.5 degrees.

All four drivers are adjustable to three degrees (one degree down and two degrees up) and different weight adjustment options are available in each model.

Callaway Quantum Triple Diamond Driver Specifications

Attic: 8 degrees, 9 degrees and 10.5 degrees

Standard length: 45.75 inches

Standard lie: 57 degrees

Adjustability: Three degrees adjustment (7-10 degrees, 8-11 degrees, 9.5-12.5 degrees)

Callaway Quantum Triple Diamond Max Driver Specifications

Attic: 8 degrees, 9 degrees and 10.5 degrees

Standard length: 45.75 inches

Standard lie: 57 degrees

Adjustability: Three degrees adjustment (7-10 degrees, 8-11 degrees, 9.5-12.5 degrees)

Callaway Quantum Max D driver specifications

Attic: 9 degrees, 10.5 degrees & 12 degrees

Standard length: 45.75 inches

Standard lie: 57 degrees

Adjustability: Three degrees of adjustment (8-11 degrees, 9.5-12.5 degrees and 11-14 degrees).

Callaway Quantum TD-TD Driver Specifications

Attic: 9 degrees & 10.5 degrees

Standard length: 45.75 inches

Standard lie: 59 degrees

Adjustability: Three degrees of adjustment (8-11 degrees and 9.5-12.5 degrees).

Adjusting the loft angle of a Callaway Quantum Driver

There are a few simple steps you can take to adjust the loft angle of your driver. All you need is an adjustment tool or wrench to get started.

To customize a Callaway Quantum driver:

1. Locate the screw on the sole of your Callaway Quantum driver that secures the driver head to the shaft.

2. Using the wrench, loosen the screw by turning counterclockwise.

3. Once the screw is fully loosened, you can rotate the adjustable hose to a lower cage or a higher cage depending on your preference. You’ll notice the loft figure you had the driver set to and you can rotate the shaft to up to eight other options.

The settings at a Callaway hostel mean the following:

• S: The loft noted, which is the loft stamped on the club head
• -1: Subtracts one degree from the indicated loft
• +1: Adds one degree to the indicated loft
• +2: Adds two degrees to the indicated loft
• N: Neutral lie setting
• D: Draw lie setting, which makes the club stand upright

4. When you have rotated the hosel to the desired loft and it is in position, slide the shaft back into your club head. Your new loft will be visible through the window to most drivers.

5. Replace the screw and tighten it clockwise with the wrench. When it is completely tight, you will hear a crank that sounds like the driver is creaking. At this point the screw is tightened as much as necessary.

Each time you want to adjust the hutch, repeat this process.